Hey DIYers! Are you hyped about the eclipse happening tomorrow? I know I am! It's really important to be safe during the eclipse though, because if you look directly at it, it'll damage your retinas. Eclipse glasses are nearly sold out, which is why today's DIY will help you view the eclipse with items you probably have around your home. It's a DIY Eclipse Viewing Box Projector! Let's get started.
You're done! I hope you enjoyed this DIY tutorial for a DIY Eclipse Box! Stay tuned for more DIYs coming soon, and stay safe!!! -Madi from DIY With Madi
Projector Using a Box
This type of pinhole projector works on the same principle as a basic pinhole projector. However, the box makes this projector much sturdier and easier to set on a surface. And it only requires a few extra items to construct.
You Will Need:
- a long cardboard box or tube
- scissors
- duct tape
- aluminum foil
- a pin or a thumbtack
- a sharp knife or paper cutter
- a sheet of white paper
Steps:
- Cut a rectangular hole at the end of the box. You can tape 2 boxes together to make a long box. The longer the box, the larger the projected image.
- Using the scissors, cut out a piece of the aluminum foil slightly larger than the rectangular hole. Make sure the foil is completely flat and not crinkled.
- Tape the foil over the rectangular hole in the box.
- Use the pin to poke a tiny hole in the center of the foil.
- Tape the sheet of paper on the inside of the other end of the box.
- Stand with your back toward the Sun. Place the box over your head with the pinhole towards the Sun. Adjust your position until you see a small projection, a reversed image, of the eclipsed Sun on the paper inside the box.
Using a Tube?
If you are using a long tube or taping 2 tubes together, cut the end of the tubes and tape the foil with a pinhole on 1 end. On the other end, tape a piece of white paper over the end of the tube. This will act as the screen. Close to this end, cut a rectangular hole using the knife. This will be your viewing window.
With your back toward the Sun, point the end with the foil toward the Sun, angling the tube along the Sun's rays. Look into the tube through the viewing window until you see a reversed image of the eclipsed Sun on the screen.
You're done! I hope you enjoyed this DIY tutorial for a DIY Eclipse Box! Stay tuned for more DIYs coming soon, and stay safe!!! -Madi from DIY With Madi
Comments
Post a Comment
Please:
NO swearing
NO rude comments
NO offensive statements
NO disturbing comments